Posts
Technical guides and supporting reads.
-
Precast vs Cast-in-Place Concrete: How Release Agent Selection and Application Change
Compare release-agent selection, spraying, coverage checks, and acceptance for precast concrete and cast-in-place work.
-
How to Clean Concrete Residue from Formwork: Steel, Plywood, and Plastic
Cleaning after concrete sticks to formwork should remove cement residue without damaging the form face. This guide compares steel, film-faced plywood, plastic, and repaired panels.
-
Concrete Sticking to Formwork: Causes, Diagnosis, and Fixes
Concrete sticking to formwork is not always only a release-agent problem. Learn how to diagnose formwork condition, release film, concrete conditions, and stripping timing before the next pour.
-
How to Set a Concrete Release Agent Spray Standard: Dilution, Coverage, and Acceptance
A practical site standard for release-agent dilution, coverage, spraying consistency, and acceptance checks before and after concrete casting.
-
Concrete Release Agent Coverage Rate: How Much Do You Need per Square Meter?
A practical method for calculating release-agent consumption per square meter, checking spray coverage, and avoiding over-application on concrete formwork.
-
How to Prevent Color Variation in Fair-Faced Concrete Across Multiple Pours
A practical process for keeping fair-faced concrete color consistent across different pours, panels, formwork conditions, and weather changes.